Ricoh L4160 Operation Manual page 48

10
Pull out the roll media out.
(1) Open the front cover.
(2) Raise the clamp lever from the back of this machine.
(3) Pull out the roll media gently and then stop pulling when
locked lightly.
11
Make the roll media even then lower the clamp
lever.
• Pulling several positions of the media lightly, Lower the
clamp lever after confirming that the amount of the roll
media pulled out is almost even.
12
Hold the media with the media press gently.
• Set the media so that no media sticks out from the right end
pinch roller to the right side.
• When using a thick media, remove the media press from
the media before printing.
2-10
• When setting a medium, be sure to cover
the medium sensors located on the rear of
the Media Transfer Surface. The media
cannot be detected unless it is placed over
the sensor.
• In case that you use 240-mm wide or narrower media, media cannot be detected if
it is set in accordance with
Do not set the media outside
•
the head.
• If a media is misaligned to the right more than fixed
position, a warning is displayed. Set the media
again.
Media press
. Set media approximately 30mm inner than
. As media may tilt and be lifted, it could break
Do not set outside
Media
ERROR 5 1 6
MED I A SE T POS I T I ON R
.
this mark.
Media Press