Track Controls > Drum Edit - Korg Pa3XLe User Manual

Track Controls > Drum Edit
In this page you can adjust the volume and edit the main param-
eters for each family of Drum and Percussion instrument for the
selected track. A list of families is shown below.
These parameters can be accessed only on tracks set to the Drum
mode (see above). Use them on tracks with a Drum Kit assigned,
or you will not be able to hear any change.
Hint: Use the TRACK SELECT button to cycle between the track
groups. After selecting a track, choose the "Solo Track" command
from the page menu to avoid listening to the other tracks during
editing.
Note: All values are offsets referred to the value of the original
Sounds.
Family Select
Use these icons/buttons to select the drum family you want to
edit. These buttons are only accessible when you select a Drum
track.
Drum family icon Drum family
Kick drums
Snare drums
Toms
Hi-Hat cymbals
Ride, Crash and other cymbals
Low-pitched percussions
High-pitched percussions
Special effects
Overview of the current parameter
Under the icons of the Drum families you can see the value of
the selected parameter for all the families. This will let you com-
pare the value of the selected family with all the others. The val-
ues are shown in grey (non editable).
Track Controls > Drum Edit
Drum Edit parameters
Use these parameters to adjust the offset value.
Sound parameters Meaning
Volume Instrument's family volume.
Attack Attack time. This is the time during which the sound
goes from zero (at the moment when you strike a
key) to it's maximum level.
Decay Decay time. Time to go from the final Attack level to
the minimum level.
Cutoff Filter cutoff. This sets the sound brightness.
Resonance Use the Filter Resonance to boost the cutoff fre-
quency.
Fine Tune Fine instrument tuning.
Coarse Tune Coarse instrument tuning.
EQ Hi Equalization, High band.
EQ Mid Equalization, Middle band.
EQ Low Equalization, Low band.
MFX 1 Send Scales the Send level to the Master FX1.
MFX 2 Send Scales the Send level to the Master FX2.
Ambience Vol Volume of the Ambience effects (environment and
mechanical noise).
Ambience T Time of the Ambience effects (environment and
mechanical noise).
0...127 Volume (see above).
-64...0...+63 Offset value for all sound generation parameters. '0'
means no change to the original value memorized in
the Drum or Percussive instrument, while any other
value means a decrease or increase to the original
value.
Select
Use these buttons to select the track to edit. The button corre-
sponding to the selected track turns green.
Reset Family
Touch this button to reset all changes to the selected family.
Reset Track
Touch this button to reset all changes to percussive instrument
volumes in the selected track.
Play/Mute icon
Track's play/mute status.
Play status. The track can be heard.
Mute status. The track cannot be heard.
How to edit a single Drum Family
Here is a quick example of the use of the Drum Volume func-
tion.
1. While in this page, press TRACK SELECT to see individual
Style tracks.
Touch the "Select" button, in the display, corresponding to
2.
the Drum track to edit.
3. Press START/STOP to let the Style go.
Style Play 125