Sample Edit > Record - Korg Pa3XLe User Manual

Professional arranger
Table of Contents

Advertisement

Sample Edit > Record
This page allows you to record a 16-bit, 48kHz stereo or mono
sample. While in this page, you will be able to monitor the input
signal. The keyboard will not play.
Record page with the Mic source selected
Record page with the Line source selected
SM (Sample)
Touch this area to open the Choose Sample window, and select
one of the available samples to be loaded in the editor.
The window will be automatically closed after selecting.
Level
Use these meters to see the level of the entering signal. When the
CLIP indicator turns red, the signal is too hot. Lower it by reduc-
ing the source output level, or by using the MIC GAIN knob on
the rear panel of the Pa3XLe.
REC Setup
Source
Use this parameter to choose either a microphone or a line
source as the input.
Line
You can connect a mono or stereo line source to
the Left and/or Right audio inputs. Use the
"Record Mode" mode parameter (see below) to
choose one or both inputs.
Mic
You can connect a microphone to the Right
Audio Input. Use the MIC GAIN knob to set the
input level.
Record Mode
Use this parameter to choose between the mono or stereo sam-
pling mode, by selecting one or both audio inputs (Left or Right)
on the back of the Pa3XLe.
Channel 1 (L) Only the Left Input is selected. A mono sample
will be produced.
Channel 2 (R) Only the Right Input is selected. A mono sample
will be produced.
Channel 1&2 (Stereo)
Both inputs will be selected. A stereo sample will
be produced.
Left to Sample
Non editable. Remaining memory (in samples/seconds) for sam-
pling. The maximum space available for samples is 1,048,576
(mono or stereo) samples, or 21.8 seconds.
Sampled
Non editable. Used memory (in samples/seconds) for sampling.
Sampling Buffer
Non editable. Available memory (in samples/seconds) for sample
editing.
Record
Touch this button to start recording. Touch it again to stop
recording. Recording will automatically stop when the maxi-
mum available space will end.
Note: Pa3XLe always samples at the maximum quality (16 bit,
48,000Hz). Samples of a different quality may be loaded (8 or 16
bit, 11,025Hz to 48,000Hz).
Sampling
241
Sample Edit > Record

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents