Platinum 2100 H Installation And Operating Manual page 86

PLATINUM inverter H
Connection to computer
86 Installation and operating manual: PLATINUM inverter H
Version 01/2012
Mat. No. 753 840-AA
If several inverters are connected via the CAN bus:
 Connect master inverter to network with CAT5 ethernet cable.
The configuration of the connection of inverter and computer depends
on whether DHCP (Dynamic Host Configuration Protocol) is available
in the network. Usually, when using DHCP, the required parameters
are assigned to the devices connected in the network by a router.
Connection with DHCP
 Call up menu Settings on inverter.
 Call up sub-menu Network Settings.
 Set the following IP address: 000.000.000.000.
 Select OK.
 Press function key
Inverter restarts and adopts the changed settings.
Connection without DHCP
 Call up menu Settings on inverter.
 Call up sub-menu Network Settings.
 Assign to inverter an unambiguous and unused IP address which
fits the network.
 Select OK.
 Press function key
Inverter restarts and adopts the changed settings.
.
.