Sbm-Xem-002 1/10 Gb Ethernet Pass-Through Module; Table 5-8. Sbm-Gem-002 Gigabit Pass-Through Module Features - Supermicro SuperBlade SBM-GEM-X2C User Manual

Superblade Network Modules User's Manual

Table 5-8. SBM-GEM-002 Gigabit Pass-through Module Features

Feature
Internal/External Ports
Remote Management
Protocols
Power Consumption
5-4 SBM-XEM-002 1/10 Gb Ethernet Pass-through
Module
The SBM-XEM-002 10-Gigabit pass-through module is a non-configurable pass through
module that includes 14 (fourteen) 10-Gb/s uplink (SFP+) ports and 14 10-Gb/s
downlink (XAUI) ports for the SuperBlade's LAN interfaces.
The SBM-XEM-002 10-Gigabit pass-through module must be installed in a double-wide
slot in the enclosure. It is installed instead of the InfiniBand module. See the SuperBlade
User's Manual for details.
NOTE: For any blade to access the 10-Gigabit pass-through module, it must
first have an AOC-IBH-003 InfiniBand card installed on its mainboard with the
appropriate 10-GbE firmware loaded on it. See
AOC-IBH-003 card.
Unlike the SBM-GEM-001 or SBM-GEM-X2C Ethernet switch modules this is a
pass-through module, and just like the
model described above, it is not configurable.
With this module Blade 1 would be connected directly to port 1, Blade 2 to port 2 and so
on. If you are connected to 10 blades then ports 11 through 14 are not connected.
Temperature and voltage of the pass-through module are read through the CMM
module. The LED's of the pass-through for a blade are only lit when the blade is on. Like
the other switches, this pass-through module is a hot-pluggable module.
NOTE: The SBM-XEM-002 10-Gigabit pass-through module must be
connected to another 10 Gigabit Ethernet switch module in order to operate. If
you connect it to a 10/100 switch, it will not work.
Description
Internal: Fourteen 1 Gbps downlink ports / External: fourteen 1 Gbps RJ45
uplink ports
NA
NA
~30.6W
GEM-002 Gb Ethernet Pass-through Module
Appendix A
6
for details on the