Removing A Switch Module; Figure 3-2. Blade Enclosure With 1/10 Gbps Switch Modules Installed - Supermicro SuperBlade SBM-GEM-X2C User Manual
Superblade network modules 1/10 gbps
Hide thumbs
Also See for SuperBlade SBM-GEM-X2C:
- Reference manual (985 pages) ,
- User manual (306 pages) ,
- Configuration manual (85 pages)
Table of Contents
Advertisement
Figure 3-2. Blade Enclosure with 1/10 Gbps Switch Modules Installed
SBM-GEM-X2C
Switch Modules
5. Push the release handle to the closed position.
NOTE: After the module has been installed and the handle locked, it will turn on
and a POST test will run to verify it is working properly. If there are no problems
the blue Init. OK LED on the module will illuminate and you will see an OK
under I
NITIATED
NOTE: If the module is installed in a top bay it must be positioned upside-down.
Removing a Switch Module
1. Pull out the release handle to the open position.
2. Pull the module out of the bay.
3. Replace immediately with another module or with a dummy module cover to
maintain airflow integrity.
in the G
E S
B
WITCH
3
Chapter 3: Setup and Installation
SBM-XEM-002 Pass-Through Module
screen of the management software utility.
Advertisement
Table of Contents
