Media Sensor - Datamax W-Class Maintenance Manual

4.9 Media Sensor

Removal:
1. Turn 'Off' and unplug the printer.
2. Remove the covers; see Section 4.1.
3. Unlatch and raise the Printhead Assembly. Remove media and ribbon from the printer.
4. Remove the two E-Clips from the Media Sensor Shaft.
5. On the electronics side of the printer, remove the E-Clip from the Media Sensor Shaft.
6. Disconnect the Media Sensor from the back plane board connector J9 and the remove the cable clamp
securing the sensor harness to the printer.
7. Rotate the Media Sensor Shaft counterclockwise until the Media Sensor Housing is free; then remove
the housing from the printer.
Removal and Replacement
4-25