Standard Cutter - Datamax W-Class Maintenance Manual

Adjustments and Maintenance
2.4.5.2

Standard Cutter

Complete the following steps to clean the Standard Cutter:
 Turn 'Off' and unplug the printer. If attached, remove the cutter tray. Raise the cover of the printer.
 Disconnect the Cutter Cable from inside the printer.
 Swing the cutter open and lift it off the Mounting Pins.
 Remove the Cover of the cutter by removing the four screws, which also secure the Left and Right
Shields to the cutter.
 Using compressed air, remove any debris from the interior cavity of the cutter.
2-31