Toshiba e-studio 2500c Operator's Manual page 296

8 JOB STATUS
Scan Job
Error code
Remote Scan
2A20
2A40
2A50
2A51
Scan to E-mail
2C10, 2C12,
2C13, 2C20-
2C22
2C11, 2C62
2C14
2C15
2C30
2C31, 2C33
2C32
2C40
2C61
2C63, 2C64
2C65, 2C66,
2C69
2C6A
2C6B
2C6C
2C6D
294 Error Code
Problem
Failed to acquire Perform the job in error again.
resource If the error still occurs, turn the power OFF and then back ON.
Perform the job in error again.
System fatal error Turn the power OFF and then back ON. Perform the job in error
again.
Job cancelling Job was cancelled.
Power failure Check if the power cable is connected properly and it is inserted
securely. Check if the power voltage is unstable.
Illegal job status A system error has occurred during sending an E-mail. Retry it.
If the error still occurs, contact your service representative.
Not enough memory Scan job exceeded the limit or maximum size. Send your docu-
ments separately.
Invalid parameter Make sure you specify the settings correctly and try again.
specified
Message size Fragment the message into several smaller-sized ones and
exceeded limit or max- send them again.
imum size
Failed to create direc- Make sure that the access privilege to the storage directory is
tory writable and the server or local disc has a sufficient space. Then
retry the scan.
Failed to create file Make sure that the access privilege to the storage directory is
writable and the server or local disc has a sufficient space. Then
retry the scan.
Failed to delete file Make sure that the access privilege to the storage directory is
writable and the server or local disc has a sufficient space. Then
retry the scan.
Failed to convert When this error occurs at the slim PDF setting, retry the scan. If
image file format the error still occurs, retry it with the normal PDF setting.
When this error occurs other than at the slim PDF setting, turn
the power OFF and then back ON. Retry the scan. If the error
still occurs, contact your service representative.
Failed to read Address Turn the power OFF and then back ON.
book Retry the job in error. Reset the data in the Address book and
retry it. If the error still occurs, contact your service representa-
tive.
Invalid domain Ask your administrator to set the IP address.
address
Failed to connect to Make sure the SMTP server is correctly working, or the SMTP
SMTP server server address has been set correctly. Then retry the scan.
Failed to send E-mail Turn the power OFF and then back ON. Retry the scan. If the
message error still occurs, contact your service representative.
Invalid address speci- Ask your administrator to check if there is an illegal character in
fied in From: field the E-mail address of the equipment. Delete the illegal character
and reset the appropriate E-mail address, then perform the job
again.
Invalid address speci- Check if there is an illegal character in the Destination E-mail
fied in To: field address. Delete the illegal character and reset the appropriate
Destination E-mail address, then perform the job again.
NIC system error Turn the power OFF and then back ON. Retry the job in error. If
the error still occurs, contact your service representative.
What to do