2 • Operation
Changing an existing job
To change an existing job...
1. Enter the setup mode as described on page 2-9.
2. Use the Change (+/-) buttons to display the job you wish to edit.
3. Use the Prev (◄) and Next (►) buttons to display the setting(s)
you wish to change.
4. Use the Change (+/-) buttons to change the options/dimensions
you wish to amend.
5. Press the Setup button to leave setup mode and save the
changes.
Deleting a job
To erase an existing job from memory, follow the steps below:
1. Enter the setup mode as described on page 2-9.
2. Use the Change (+/-) buttons to display the job you wish to
delete.
3. Press the Delete button. The display reads "Press again to
confirm". Press Delete again. The display will briefly read
'Deleting Job' as the job is erased.
4. Press the Setup button to leave setup mode.
2-22
SDC639A