Pitney Bowes OfficeRight DI380 Operator's Manual page 9

Insert Feeder Use this feeder to add additional inserts to your
3
envelope. Material fed from this feeder cannot be folded by the
inserter. However, this feeder is especially suited to feeding
pre-folded or thicker inserts.
4
Fold Plates 1 and 2 These units are used to create the
desired fold in material fed from the Sheet Feeder(s). The Fold
5
Plates are automatically set from the Control Panel.
Display/Control Panel This is where you enter commands
6
and where the machine informs you of its status with the use
of symbols and icons. Full details of each button function are
given on the following page.
Drop Stacker or Output Device (not illustrated)
7
A fold down stacker is located at the exit from the machine
to collect the finished Mail Pieces. This unit can be latched
against the machine when not in use. Alternatively, a range of
power stackers are available which offer greater capacity than
the standard Drop Stacker.
A Mailing Machine Interface can be fitted in place of a stacker
which automatically transports Mail Pieces to a Pitney Bowes
Mailing Machine for postal 'franking'.
8 Manual Advance Knob The Manual Advance Knob is located
inside an opening cover at the lower centre of the machine.
It can be used to manually turn the machine mechanisms to
assist in clearing a material stoppage.
Envelope Feeder This feeder feeds envelopes into the
9
inserting area where they are filled with the material requested
from the other feeder(s).
Sealer Bottle The sealer bottle is located inside an opening
10
cover at the front right side of the machine. It provides sealing
solution to the Envelope Sealer.
11
Measuring Scale The scale is located on the left side of
the machine near the sheet feeders as an aid in measuring
material and envelopes.
12
Envelope Inverter This unit exits the envelope into the
stacker face up.
SDC639A
Introduction • 1
1-5