Detailed Parameter Description; Function Of Parameter - Panasonic M2X Series Instruction Manual

Detailed Parameter Description

Function of parameter

No. Parameter name
Set frequency
(0th speed)
1st speed frequency
2nd speed frequency
3rd speed frequency
4th speed frequency
5th speed frequency
6th speed frequency
7th speed frequency
8th speed frequency
9th speed frequency
10th speed frequency
11th speed frequency
12th speed frequency
13th speed frequency
14th speed frequency
15th speed frequency
Run command
selection
Frequency command
selection
■: Factory setting
Used to specify desired operating frequency.
Enabled when [ Frequency command selection] is set to
Used to specify frequency for multi-speed operation.
Enabled when [ Operation mode selection] is set to 4-, 8- and 16-speed
operation modes.
Operation
I3
mode
2-speed CCW
mode jogging
4-speed
mode
8-speed Frequency setting
mode
16-speed
mode
Run command can be selected through the following control facility.
(PaNeL)
●
(TERminal) : Input terminal [I I I I 1]/[I I I I 2]
●
(BOTH)
■
● (SIG)
When is selected, the input terminal cannot be used for run
*
command.
Used to select whether [
terminals (FIN1 and FIN2) or the inverter's control dial is used for the 0th speed
frequency setting.
■ [
Analog command
●
FIN1 (Voltage command) 0 to 5 VDC
FIN2 (Current command) 4 to 20 mA
● Analog command
FIN1 (Voltage command) 0 to 10 VDC
FIN2 (Current command) 4 to 20 mA
Inverter's control dial
●
∗ If
is selected for the inverter that is not equipped with the control
dial, the 0th speed frequency setting is disabled.
- -
45
Description
I4 I5
Select among:
CW jogging
free-run, external forced trip,
No.2 acceleration/deceleration
and trip reset.
selection
: RUN switch on the operation panel
: Both operation panel and input terminals can
be used.
: RS485 communication
Set frequency (0th speed)], frequency setting input
Set frequency (0th speed)]
.
I6