Wireless Isp; Wan Interface Setup - Modecom MC-421 User Manual

WLAN Router

Wireless ISP

In this mode, all ethernet ports are bridged together and the wireless client will connect to ISP access point. The
NAT is enabled and PCs in ethernet ports share the same IP to ISP through wireless LAN. You must set the wireless
to client mode first and connect to the ISP AP in Site-Survey page. The connection type can be setup in WAN page
by using PPPOE, DHCP client or static IP.
To change the Operation Mode:
From the left-hand menu, click on Quick Setup. The following page is displayed:
Click on the ratio of Wireless ISP and then click on Next>>.

WAN Interface Setup

This page is used to configure the parameters for Internet network which connects to the WAN port of your Access
Point. Here you may change the access method to static IP, DHCP, or PPPoE by click the item value of WAN Access
type.
To change the WAN Access Type:
From the WAN Access Type drop-down list, select Static IP, DHCP Client, or PPPoE setting determined by your
Network Administrator or ISP.
Click Next>>.
www.modecom.eu
24