Leveling Procedure - Fleetwood American Dream WIDE BODY 1998 Owner's Manual

6
Page 2 of 5
SEMI-AUTOMATIC
LEVELING SYSTEM
LEVELING PROCEDURE
Before you operate the leveling system, verify the following:
A. TM engine is running.
B. The automotive batteries are ON (check the disconnect
switches) and have a minimum charge of 11 volts.
C. The brake, system is functioning (at least 90 psi on the air
pressure gauge) and the PARKING BRAKE is set.
D. The transmission selector is in NEUTRAL.
E. The leveling system is ON.
F. There are no obstructions anywhere under the motor
home.
To level the unit:
1.
Press ON/OFF switch on control panel. ON/OFF light
and Electronic Level lights will illuminate .
. 2. Check top see that the excess slope indicator is not
flashing. If excess slope indicator is flashing, move the
motor home to a more level location.
3. Push and hold the ALL JACKS DOWN pad until you
feel the jacks contact the ground. '
4. Observe the FRONT and the REAR Electronic Level
lights (arrows). Push and hold the corresponding pad
until the pump turns off and leveling action stops.
5. Observe the LEFT and RIGHT Electronic Level lights
(arrows). Push and hold the corresponding pad until the
pump turns off and leveling actions stops.
6. Observe the green level indicator light. It should be ON,
indicating that the motor home is level. If it is not ON,
repeat steps 4 & 5.
=============
American Dream
=============
Wide Body
- ISSUE DATE: 6/97
© 1997 Fleetwood Enterprises, Inc. All rights reserved
.-