Living With Your Motor Home; Leveling System (If Equipped); Power Entry Step (If Equipped) - Fleetwood 2014 Terra Storm Owner's Manual

Table of Contents

Advertisement

LEVELING SYSTEM
Controls for the leveling system are located in the
driver's compartment. A detailed operating and
maintenance guide is included in your Owner's
Information Package. Read all instructions for
this system carefully before operating the system .
!
WARNING
The leveling system is designed as a leveling sys-
tem only. Do not use the system as a jack or with a
jack. Do not attempt to raise the tires off the ground.
The system should be used to raise the recreational
vehicle to the lowest level position possible.
NOTE
3
After the leveling system has been deployed verify
that each jack is touching the ground. Manually
deploy jacks that are not touching the ground.
NOTE
3
In the event the leveling system "locks up" and the
key pad is non-operational, cycle the ignition "off to
on" to reset the leveling system. Follow the intructions
from the leveling system supplier to continue.
For operation of the leveling system the
following is required:
• Park the RV on level ground
• Ignition on, engine running
• Transmission in park
• Parking brake set to the engaged position
• Battery Voltage must be 13.0 Vdc
or greater
• Do not move around unit while leveling
POWER ENTRY STEP
The power entry step is controlled by a magnetic
entry door position switch, the engine ignition
switch and by an entry step switch located near
the entry door. Power for the entry step is sup-
plied by the chassis battery (or batteries). The

LIVING WITH YOUR MOTOR HOME

(If Equipped)
battery system must be connected (battery dis-
connect in the "ON" position) for the entry step
to operate.
!
WARNING
Always look and be sure the step is extended before
entering or exiting the motor home.
!
WARNING
If door is quickly opened and closed without allowing
the step to fully extend and lock in the "OUT" position,
the step will immediately retract and lock in the "UP"
position.
The entry step will typically extend and retract
with the opening and closing of the entry door
as controlled by the entry door position switch
(function is automatic). Activating the entry step
switch will move the entry step to the extended
position, and it will stay there regardless of
whether the door is open or closed. Regardless
of the entry step switch position, activation of
the ignition key with the entry door closed will
retract the entry step. This helps to prevent inad-
vertently driving off with the entry step extend-
ed. The switches operate the entry step according
to the following table.
Refer to the power step Owner's Manual in your
Owner's Information Package for details on
maintenance and lubrication .
Ignition
Entry Step
Switch
Switch
Position
Position
OFF
OFF
OFF
ON
ON
ON/OFF
Step
Position/
Action
Step extends and retracts
with the opening and closing
of the door.
Step stays in the extended
position regardless of door
open or closed position.
Step retracts when the door
is closed.
06-1

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents