Fleetwood American Dream WIDE BODY 1998 Owner's Manual page 106

22
Page 2 of 11
FRESH WATER SYSTEM
To Connect to City Water Without Filling the On-board Tank
(See the iIIustratiQns)
1. Open the plumbing utility compartment door. The city
water inlet is in this compartlll«nt. This inlet is a female
garden hose fitting-with a one-way check valve.- -
2. Connect one end of a potable water supply hose to the park
or campground city water supply outlet, which will be a
male garden hose fitting, similar to your garden hose valve
at home. "Potable water" hoses are available at RV supply
stores.
3. -Tui'n the city water supply outlet valve ON and let it run for
a few seconds to clear the line and hose. Turn the outlet valve
OFF.
4. In the plumbing utility compartment, turn the WATER
TANK BYPASS valve, the COLDWATER DRAIN valve,
and the HOT WATER DRAIN to the right (clockwise) to
close -them, if necessary.
5. On Model WF and yS, tum VALVE 2 vertical and VALVE
-1 horizontal. On Model AF, -turn VALVE 2 horizontal and-
turn the handle on VALVE 1 toward the front of the vehicle.
6. Attach the free end of the city water supply hose to the city-
water inlet fitting. Tighten securely,
7. Turn the city water supply.valve ON. The system is now
pressurized by the city water supply. Water is available at the
--exterior utility washdown faucet and all interior faucets.
8. Open each faucet in the galley and bathroom. After any
sputtering stops and water flows freely, close the faucet.
As long as
YOlT
are connected to a cit/water supply, you have pressurized
water at all faucets. You do not need to run the wafer pump. With the valves set
this way, the water pump is isolated from the system.
© 1997 Fleetwood Enlerpris_es Inc.
American Dream
========~====
Wide Body
ISSUE DATE: 6/97
AU rights reserved