Removing The; Unpacking And Installing Outdoor Unit Dhp-A; Installing The Stand On Outdoor Unit Dhp-A; Installing The Defroster Sensor, Dhp-A - Danfoss DHP-H Installation And Service Instructions Manual

4 .2 Removing the front cover
NOTE! Do not damage the electrical wiring for the control sys-
⚠
tem when the front cover is removed!
To install the heat pump the front cover must be removed.
Figure 18: Removing the front cover .
1 Unscrew the screws (3).
3 Slide the front cover (2) upwards and carefully lift it off upwards
and forwards.
4 Place the front cover next to the heat pump.
4 .3 Unpacking and installing outdoor unit
DHP-A
The outdoor unit is packed and delivered in a wooden crate.
1 Start by unpacking the unit from the wooden crate.
2 Check that the delivery is complete, it must contain the outdoor
unit as well as a package containing the disassembled stand
including necessary screws, nuts and washers.
4 . 4 Installing the stand on outdoor unit DHP-A
Figure 19: Stand for outdoor unit DHP-A .
1
2
1 Screw the two horizontal struts together (1) using the two ends
(2). The curved edge of the horizontal struts must be facing
upwards. Screws and washers for installation are supplied.
2 Press the adjustable feet into the holes under the ends.
Figure 20: Installing the outdoor unit on the stand .
3 There are two pre-drilled holes in the bottom plate of the out-
door unit where the stand is screwed into place with 2 screws
per side.
4 Hook the cover onto the stand.
NOTE! Remember that the water that drips from the outdoor unit
during defrost must be able to drain into the ground. The outdoor
unit must therefore not be positioned on asphalt or slabs where
water cannot drain easily. If this is not possible, connect a hose to
the defrosting outlet and route it away from the outdoor unit.
4 .5 Installing the defroster sensor, DHP-A
Install the defroster sensor on the reverse of the outdoor unit.
2
3
VMBMA102
1