Low Voltage Connections - Cyclo Vac GS71 Owner's Manual

LOW VOLTAGE CONNECTIONS

Connect the low voltage wires to the low
voltage inlet on your unit. To do so, simply
strip wires over 1/2 cm (1/4"), remove the
terminals from the low voltage inlet on the
unit, and proceed according to the types of
inlet and wire used.
STANDARD LOW VOLTAGE INLET
All types of wire
Twist the stranded wire to tighten the loose
strands together before proceeding. Insert the
wire into the terminal (blue connector). Using
your wire strippers, tighten the terminal at two
places: at the front, to hold the wire in place,
and at the back, to tighten the insulator
around the wire (figure 2). If the insulator
does not completely cover the stripped
wire, use electrical tape to insulate the wire
adequately, and prevent all contact between
the 2 wires. Insert the terminal into the low
voltage inlet (figure 3).
To disconnect
Do not pull on wire. Simply remove the
terminal from the low voltage inlet.
8 Installation
figure 2
figure 3