Set-Up; Auto Off Safety System - Pace 20A Operation & Maintenance Manual

Set up the ST 20A system using the following steps and associated drawings. If you
have purchased a system which includes the TT-65 ThermoTweez handpiece or the
PS 50 Prep-Set system, refer to their Operation & Maintenance manuals for
applicable set-up instructions for those items.
1. Store the shipping container(s) in a
convenient location. Reuse of these
containers will prevent damage if you
store or ship the system.
2. Place the Power Switch in the "OFF" or
"0" position.
3. Place 4 of the supplied Rubber Feet on
the base of the power source. Remove
the paper backing and place in corner
indentations. Refer to illustration below.

Auto Off Safety System

The Auto Off Safety System removes power
from the connected handpiece after 90
minutes of handpiece inactivity. As
received from the factory, the feature is
Disabled ("2" position). The LED on the
front panel will illuminate Yellow in color
(with handpiece connected).
Refer to the description of the Auto Off Safety
System detailed in the "Operation" portion of
this manual.
To Enable ("1" position) the Auto Off feature,
perform steps 1-3.
1. Place the power source on a work
surface with the bottom facing up as
shown in the illustration.
2. Move the switch to the "1" (Enable)
position. During normal use, the LED
will now be illuminated Green in color
(with handpiece or PS-50 connected).
3. Position the system upright on a
convenient bench.

Set-Up

7