Replacement Parts; Sp-1A/Sp-2A Handpieces - Pace 20A Operation & Maintenance Manual

Hide thumbs

Table Of Contents

Table of Contents

6. Plug the wire leads of the replacement Heater Assembly into the wire

leads of the Cable Assembly using the table shown in the illustration as a

reference. Match like colored wires. Connect the Green Cable Assembly

lead to the non-insulated Heater Assembly lead. Insure that the leads do

not become crossed with each other.

7. Slide the Insulator over the lead connections and against the back of the

heater housing. The metal tab on the heater housing (Heater Tab) must

slide in the Wide Notch (see illustration) on the end of the Insulator.

8. Gently pull the Cable Assembly back through the handpiece until the

Heater Assembly rests against the plastic Handle. Gently twist the Heater

Assembly (if necessary) to slide the narrow notches on the Insulator

between the tabs on the inside of the Handle.

9. Place the new metal Compression Spring over the end of the Heater

Assembly .

10. Install the new Heater Retaining Nut to secure the Heater Assembly and

rubber Compression Spring to the Handle.

11. Tighten the white plastic Strain Relief Screw (if present) located at the

rear of the Handle until the screw is flush with or just above the Handle

surface to secure the cable assembly in position. A replacement screw is

supplied in the event that replacement becomes necessary.

12. Perform the Burn In procedure (listed on the Red tag packaged with the

replacement Heater Assembly) to insure long life.

SP-1A/SP-2A Handpieces

Listed are the replacement parts which may be ordered through your local authorized

PACE distributor. To obtain any other replacement parts, contact PACE Customer

Service directly at Tel. #(301) 490-9860 or FAX #(301) 604-9215.

Item

Description

SP-1A Sodr-Pen Handpiece

SP-1A Heater Assembly (37 Watt) 6010-0085-P1

SP-2A Sodr-Pen Handpiece

SP-2A Heater Assembly (54 Watt) 6010-0086-P1

Heater Set Screw

Table IV. SP-1A/SP-2A Parts