Configuring The Basics - GeoVision GV-IP Decoder Box User Manual

5.3 Configuring the Basics

After you have installed and connected the necessary wire and cable to your GV-Pad, you are
ready to configure the GV-Pad.
1. Configure the IP address, ID and password. See 2.3 Configuring the IP Address, ID and
Password.
Note:
1. Since all the GV IP devices have the default IP address 192.168.0.10. Therefore, it is
strongly advisable to modify the IP address to avoid IP conflict.
2. The default ID and password are admin.
3. The IP devices to be connected need to have the same ID and password set on the
GV-Pad.
2. Display channels. The GV-Pad can display up to 64 IP channels from GeoVision and/or
third-party devices. Refer to the sections indicated below to set up the channels.
Functions
To display channels from GV
IP devices
To display channels form
third-party IP devices
To display channels connected
to GV-System
50
Reference
See 2.4 Displaying Channels from GV IP
Devices
See 2.5 Displaying Channels Using GV IP
Device Utility
See 2.6 Displaying Channels from GV-System