Invacare rea Azalea Assist Manual page 22

5.8.2 Fixed legrests, height adjustment
B
A
Loosen screw (A) with an Allen key. Adjust the
legrest into a suitable height and the screw is caught
by one of the recesses on the legrest tube. Then
retighten the screw.
NOTE! Don't touch the upper screw (B).
The distance between the lowest part of
the footrest and the ground must be at least
40 mm.
5.8.3 Central legrest
5.8.3.1 Leg angle adjustment
A
Adjust to the appropriate leg angle using knob (A).
When adjusting the angle of the central legrest,
loosen the adjustment knob with one hand and
hold the foot plate with the other hand to avoid
trapping yours or anyone else's fingers etc.
When the seat is tilted forwards on a chair
with a long legrest length and low seat height,
there is a risk of the legrest hitting the floor
and causing damage.
22
5.8.3.2 Height adjustment
B
C
You can adjust the height of the legrest in the fol-
lowing two ways:
Alternative 1:
Loosen the Allen screw (B) using a 5 mm Allen
key on the front of the telescopic tube, place the
legrest in the desired position and secure it into
place using the Allen screw.
Alternative 2:
Loosen the Allen screw (C) by the legrest attach-
ment as shown in the diagram. Adjust to the
desired height and then retighten the screw.
5.8.3.3 Foot angle adjustment
D
Loosen the rear screw (D) on the side of the tube
using a 5 mm Allen key and adjust the legrest to the
desired angle. Retighten the screw. Repeat this pro-
cedure to adjust the angle of the other legrest.
5.8.3.4 Depth adjustment
E
Loosen the frontal screw (E) on the side of the tube
to adjust the depth of the legrest. Tighten the screw
when you have found the desired depth. Repeat this
procedure to adjust the depth of the other legrest.
Azalea
R