Configuration And Operating Instructions - PSG CADDY ALTERNA Installation And Operating Instructions Manual

Pellet furnace

Hide thumbs Also See for CADDY ALTERNA:

Table of Contents

CONFIGURATION AND OPERATING INSTRUCTIONS

Before you configure your system and learn how to operate it, it is important to note that your Caddy Alterna is

equipped with 3 main electronic components: the main control board, the pellet central processing unit (Pellet CPU),

and the LCD user interface. The main control board is already attached to the furnace. The main control board will

only need to be accessed if the fuses need to be replaced.

The pellet central processing unit (Pellet CPU) is used for the system configuration. More precisely, it is used for the

following:

Programming the different modes (HEAT, MANU, CIRC, and COOL);

Choosing the selections (TEMP, UNIT) for HEAT mode and (TEMP, UNIT and FAN) for MANU, CIRC or

COOL mode;

Connecting the RTD temperature sensor;

Connecting the thermostats;

Connecting the electrical element option.

The LCD user interface is used for the system's operation. More precisely, the LCD interface is used for the

following:

Choosing the maximum BTU input;

Choosing the pilot mode lag time;

Filling up the auger;

Starting the furnace;

Turning the furnace off;

View the flue temperature;

Choosing the manual or thermostatic mode;

Select language;

View statistics;

Changing

F to

Troubleshooting the unit.

The pellet central processing unit (Pellet CPU) (system configuration) – See next page

Table of Contents