Section 1: Building The Boat Stand; Section 2: Attaching The Turn Fin - Pro Boat 1/8-Scale Formula Hydro Unlimited Hydroplane Owner's Manual

Parts Required
Plywood boat stand pieces (4)
Tools and Adhesives Needed
CA or epoxy
 1. Attach the side boat pieces by interlocking
them into the end pieces as shown.
Parts Required
Turn Fin
3mm hex screws (2)
Tools and Adhesives Needed
3mm hex driver
Blue Threadlock
 1. Locate the included turn fin. This will be
attached to the right sponson. Any attempt to
turn the boat left may cause the boat to flip,
especially if this is done in a tight diameter and
at high speeds.
 2. Place the Formula Hydro on the completed
boat stand once the glue has fully cured.
 3. Locate the turn fin and the included 3mm
hex screws (2) to secure the turn fin.

Section 1: Building the Boat Stand

Section 2: Attaching the Turn Fin

 2. Secure the interlocking boat stand with
medium thick CA or epoxy. Make certain you
allow the CA or epoxy to fully cure before
placing the boat on the stand.
 4. Carefully place a few drops of blue
Threadlock on the threads both hex screws.
This will help to keep the screws secured to the
blind nuts within the sponson.
 5. Carefully attach the turn fin onto the right
sponson as shown and tighten the hex screws
with a 3mm hex driver.