Section 1: Boat Stand Assembly; Section 2: Removing The Canopy; Section 3: Installing The Radio System Batteries; Section 4: Installing The Wing - Pro Boat ShockWave 55 Owner's Manual

Section 1: Boat Stand Assembly

There are 4 plywood boat stand pieces. The 2 short plywood
pieces are the ends of the boat stand.
Secure the 2 long plywood pieces of the interlocking boat stand to
one end of the short plywood pieces. Repeat with the remaining
short plywood pieces.
Secure the stand together where each piece is joined with epoxy
or CA glue (not included).

Section 2: Removing the Canopy

Unscrew the 2 knurled hatch-mounting screws from the rear of
the hatch. Slide the front hatch retainer toward the rear of the
boat and lift the hatch from the boat.

Section 3: Installing the Radio System Batteries

Receiver Batteries
Remove the 10 2.5mm hex head screws that secure the clear
Lexan radio box cover.
Remove the receiver battery holder and install 4 "AA" alkaline
batteries in the battery holder. Note proper polarity.
7672_PRB_shockwave55ss_manual2.indd 4-5
4
Section 3: Installing the Radio System Batteries (cont.)
Reinstall the battery holder into the radio compartment.
Secure the radio box cover with the 6 Phillips screws.
Transmitter Batteries
Remove the transmitter from the box.
Remove the battery cover on the bottom of the transmitter.
Insert 8 "AA" alkaline batteries into the battery holder.
Note proper polarity.
Turn on the transmitter and confirm that the LCD illuminates,
indicating proper installation of fully charged batteries.
Turn on the receiver switch and move the controls. Confirm that
all controls operate in the proper direction and are controlled by
the proper transmitter input.
Turn the transmitter and the receiver switch off. To keep the boat
from receiving stray signals, the transmitter should be turned on
first, followed by the receiver. Likewise, the receiver should be
turned off first, then the transmitter.

Section 4: Installing the Wing

Install the wing in the direction shown.
Install the four 3mm x 20mm hex head screws and secure with
the four 3mm nuts.
Apply screw-locking compound to the threads to lock the nuts
in place.
NOTE: The wing is not intended to be a handle.
5
6/23/05 9:28:13 AM