Contents; Additional Required Items; Section 1: Assembling The Boat Stand; Section 2: Installing The Transmitter Batteries - Pro Boat Miss Elam Owner's Manual

You will need to purchase the following to get your boat on the water:
• 4 AA alkaline batteries for the radio transmitter
• 7 .2V Ni-MH Battery Pack with Deans connector (PRB3316) (2)
OR 7 .4V 5300 25C LiPo (DYN5360D) (2)
• Twin Peak Dual Battery Charger (DYN4033)
• Tamiya/Deans adapter (PRB3312)
Attach the side stand pieces by interlocking them into the end pieces
as shown . Secure the interlocking pieces with medium CA or epoxy .
Make certain you allow the adhesive to fully cure before placing your
boat on the stand .

Section 2: Installing the Transmitter Batteries

Install 4 fully charged AA alkaline batteries into the transmitter,
following the instructions provided for your radio system . Be sure to
install the batteries with respect to proper polarity .

Contents

Additional Required Items

Section 1: Assembling the Boat Stand

• Miss Elam Brushless EP RTR
• Pro Boat radio transmitter
• Boat stand
4
4
PRB3316
5100mAh