Section 1: Building The Boat Stand; Section 2: Rudder Installation - Pro Boat Vortex 46 Airboat Owner's Manual

 1. There are 4 plywood pieces. The 2 short
plywood pieces are the ends of the boat stand.
 2. Attach the 2 long plywood pieces of the
interlocking boat stand to one end of the short
plywood pieces. Repeat with the remaining short
plywood pieces.
 3. Secure the interlocking boat stand with thick
CA or Epoxy.
Parts Needed
Rudder
Phillips rudder mounting screw
 1. Locate the rudder and the Phillips rudder
mounting Screw.
 2. Carefully insert the rudder shaft into the
bottom of the rudder strut and through the
control arm.

Section 1: Building the Boat Stand

Section 2: Rudder Installation

 3. Find the predrilled hole in the rudder shaft.
Using a #1 Phillips screwdriver, tighten the
screw as shown.
5