Additional Required Items; Suggested Field Equipment And Supplies; Section 1: Building The Boat Stand; Section 2: Removing The Canopy - Pro Boat Owner's Manual

Additional Required Items

Although the HyperSport™ 48 comes fully
assembled and ready for action, you will need
a few additional items in order to run your
boat. You will need the following:
®
• Evolution Synthetic 2-Cycle Oil, quart
(EVOX1001Q)
• Flex Shaft Lubrication (PRB0100)
• Fuel Pump (HAN155)
• 8 AA alkaline batteries
(4 for the transmitter and 4 for the receiver)
• CA or epoxy glue
• Fuel container
• Gasoline (+87 Octane), ethanol-free
Suggested Field Equipment
and Supplies
In addition to the items needed to run the
HyperSport 48, we recommend that you carry
the following in your field box:
• Engine Tuning Screwdriver (DYN3048)
• Extra Propellers (PRB2369)
• #1 Phillips screwdriver
• 8mm wrench
• Screw-locking compound
• Clean towels
• Hex wrench: 2mm, 2.5mm, 4mm
• 16mm wrench (2)
• Wax
Section 1: Building
the Boat Stand
1. There are 4 plywood boat stand pieces.
The 2 short plywood pieces are the ends
of the boat stand.
2. Secure the 2 long plywood pieces of the
interlocking boat stand to one end of the
short plywood pieces. Repeat with the
remaining short plywood pieces.
Section 2: Removing
the Canopy
Unscrew the knurled hatch-mounting screw
from the rear of the hatch. Lift the hatch
from the rear and pull to the rear.
4 4