Transmitter Batteries - Pro Boat 1/8-Scale Formula Hydro Unlimited Hydroplane Owner's Manual

Section 4: Installing the Radio System Batteries (cont)

Transmitter Batteries

 1. Remove the transmitter from the box.
 2. Remove the battery cover on the bottom
of the transmitter.
 3. Insert 8 "AA" alkaline batteries into the
battery holder. Note proper polarity.
 4. Insert the battery holder in the transmitter
following the directions provided with the
radio system.
 5. Install the battery cover back into position on
the bottom of the transmitter.
 6. Turn on the transmitter and confirm that the
LCD illuminates, indicating proper installation of
fully charged batteries.
 7. Turn on the receiver switch and move the
controls. Confirm that all controls operate in
the proper direction and are controlled by the
proper transmitter input.
 8. Turn the transmitter and the receiver switch
off. To keep the boat from receiving stray
signals, the transmitter should be turned on first,
followed by the receiver. Likewise, the receiver
should be turned off first, then the transmitter.
Note: Remember the transmitter
must be sending a signal the entire
time the receiver is on.