Pro Boat ShockWave 36 Owner's Manual
  1. Manuals
  2. Brands
  3. Pro Boat Manuals
  4. Toy
  5. ShockWave 36
  6. Owner's manual

Pro Boat ShockWave 36 Owner's Manual

.32 size nitro powered deep-v boat
Hide thumbs
Table of Contents

Advertisement

Quick Links

.32 Size Nitro Powered Deep-V Boat
Owner's Manual
Specifications
Length................................................................................................................ 36 in (914mm)
Beam.................................................................................................................... 9 in (228mm)
Engine ................................................................ DYN .32 Marine w/Recoil and Tuned Exhaust
Radio System ........................................................................................ JR AM 75MHz Python
Weight ................................................................................................................ 6.5 lb (2.9 kg)
Fuel Tank Capacity .......................................................................................... 12 oz (0.35 liter)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ShockWave 36 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Pro Boat ShockWave 36

Summary of Contents for Pro Boat ShockWave 36

  • Page 1 .32 Size Nitro Powered Deep-V Boat Owner’s Manual Specifications Length........................ 36 in (914mm) Beam........................9 in (228mm) Engine ..............DYN .32 Marine w/Recoil and Tuned Exhaust Radio System ..................JR AM 75MHz Python Weight ........................ 6.5 lb (2.9 kg) Fuel Tank Capacity ..................12 oz (0.35 liter)

  • Page 2: Table Of Contents

    Pro Boat ShockWave 36 in low wake, low wind conditions. We could go out of control, possibly causing damage to the models, also suggest that you do not run the ShockWave 36 in salt water. as well as to others.

  • Page 3: Additional Required Items

    Clear tape to seal radio box Suggested Field Equipment and Supplies In addition to the items needed to run the ShockWave 36, we recommend that you carry the following in your field box: Engine Tuning Screwdriver (DYN2775) Replacement Glow Plugs (DYN2508 or DYN2500) Hex driver/Allen wrench (2.5 mm)

  • Page 4: Section 1: Installation Of Receiver And Transmitter Batteries

    Section 1: Installation of Receiver and Transmitter Batteries Receiver Batteries Antenna Tube Re-install the battery holder into the radio box and properly seal the radio box with clear tape. Failure Remove the knurled aluminum nut that secures the to properly seal the radio box could result in damage cockpit.

  • Page 5: Section 2: Rudder Installation

    (engine off), walk off Note: It is a good idea to range check prior to operating 40 to 50 paces from the ShockWave 36. your boat after any repair, installation of new batteries, or 2. Have an assistant remain with the boat to check for proper control at the beginning of each boating season.

  • Page 6: Section 6: The Dynamite .32 Marine Engine

    Section 6: The Dynamite .32 Marine Engine Water-Cooled Engine Breaking in Your Engine Because the Dynamite .32 engine is water-cooled and not air- The first start-up of the engine is the most critical moment of the ® cooled, make sure that you do not run the engine for an extended engine’s life, dictating how the engine will perform from that time amount of time outside of the water.

  • Page 7: Troubleshooting Guide

    Wipe off any exhaust residue from the boat. If you operate the ShockWave 36 in salt water, it is suggested that you thoroughly Before operating ShockWave 36 rinse the deck, hull, and all the metal hardware with fresh Check that all screws and hardware are securely in place.
  • Page 8 Section 7: Maintenance (cont.) Lubrication It is important to lubricate the drive shaft of the ShockWave ™ with silicone cable grease after every two hours of operation. You can purchase this silicone grease at your local hobby store. To lubricate the drive shaft, follow these simple instructions. Retaining Collet Flywheel...

  • Page 9: Section 8: Shockwave 36 Replacement Parts

    Section 8: ShockWave 36 Replacement Parts In the event that you need to purchase replacement parts for your engine or the ShockWave 36, please see your local hobby store. ™ You can also purchase them from Horizon Hobby by calling 1-800-338-4639 or shop online @ www.horizonhobby.com...
  • Page 10 ™ Look for these other fine Pro Boat models at your local hobby dealer. • Professionally painted and detailed fiberglass hull • Speeds up to 30 mph • JR XR3i FM pistol-grip radio system installed • Water-cooled Dynamite ® • Professionally painted and decaled fiberglass hull .15 Marine nitro engine...

  • Page 11: Notes

    Notes MADE IN CHINA © 2004 Horizon Hobby, Inc. www.horizonhobby.com 6605...

Table of Contents