Table of Contents
Advertisement
52 Installing and configuring the VCS One Policy Master
Configuring the Policy Master
5
Enter the name of the volume for the configuration database. For example,
enter the following: pmvol.
6
Do one of the following:
If you are prompted to enter
the volume size
If you are not prompted to
enter the volume size
7
Enter the volume size. For example, enter the following: 200M.
8
Do one of the following:
If the volume is not mounted, go to
■
■
If the volume is already mounted, go to
configuration.
9
Enter the mount point for the configuration database. For example, enter
the following: /PM.
10 At Storage Foundation configuration verification prompt, enter the
following: y.
If the installer uses an existing disk group for the configuration database,
you are prompted about cleaning up the shared storage directories.
11 If you are prompted to clean up the shared storage directories, enter the
following: y.
Configuring NetApp Filer
Follow the instructions in this section to configure Network Appliance filer
(NFS) to store your configuration information. Only Network Appliance filers
are supported as NetApp servers.
To configure Network Appliance Filer
1
Enter the mount point for the configuration database. For example, enter
the following: /software/vcsone.
The installer mounts the mount point. If the mount point is already
mounted, you can choose to unmount it through the installer.
2
Enter the fully-qualified host name or IP address for the NetApp Filer. For
example, enter the following: netapp3.veritas.com.
3
Select an access method (rsh, ssh, or api).
4
Enter the name of the user who accesses the Network Appliance filer. For
example, enter the following: root.
Go to
step
7.
Go to
step
8.
step 9
and enter the mount point.
step 10
and verify your
Advertisement
Table of Contents
Troubleshooting
