Upgrading A 2.0.1 System And Adding It To The Vcs One - Symantec XGS-4728F Installation Manual

146 Sample Policy Master upgrade scenarios
Upgrade scenario details
Verifying VCS One operations on the new system
Verify the VCS One operations on Node2 for as long as you choose. The
verification period can last from several minutes to days.
To verify VCS One operations on the new system
◆
Monitor the Policy Master service group to ensure that it is continuously
online. Enter the following:
# /opt/VRTSvcsone/bin/hagrp -state
Migrating configuration and database data to a new system
Migrate the VCS One 2.0.1 Symantec Product Authentication Service and
database data. Migrate the data from Node1 to Node2
To migrate configuration and database data to a new system
◆
Enter the following:
# ./installvcsonepm -migrate
For more information on migrating configuration and database data to a
new system, see "Migrating your 2.0.1 configurations to VCS One
page 120.

Upgrading a 2.0.1 system and adding it to the VCS One 5.0

Policy Master cluster
Follow the instructions in this section to upgrade Node1 to VCS One 5.0, and
then add it to the VCS One 5.0 Policy Master cluster.
To upgrade a 2.0.1 system and add it to the VCS One 5.0 Policy Master cluster
1 Check that Node1 is running an operating system that VCS One 5.0
supports. Do one of the following
■ If Node1 is running a supported operating system, skip to
■ If Node1 is not running a supported operating system, install or
upgrade to a supported operating system. Then, go to
For information on supported operating systems, see Veritas Cluster Server
One Release Notes.
2 Use the Policy Master installer to upgrade Node1 to VCS One 5.0. You don't
need to configure the system. Use the -installonly option to install the VCS
One packages over the systems. Enter the following:
# ./installvcsonepm -installonly
5.0" on
step 2.
step 2.