Table of Contents
Advertisement
Starting the migration
To start the migration
1
Navigate to the directory that contains the migration script. For example,
enter the following:
# cd /mnt/rhel5_x86_64/cluster_server_one/
2
Start the migration. Enter the following:
# ./installvcsonepm -migrate
You see some information about the migration process.
3
Press Enter.
Specifying the target systems
You must specify the names of the 2.0.1 systems that contain your
configurations, and the target VCS One 5.0 systems to which you want to
migrate your 2.0.1 configurations.
To specify the target systems
1
Enter the names of the 2.0.1 systems. For example, enter the following:
my_machine1 my_machine2
2
At the system names prompt, enter the names of the target VCS One 5.0
systems to which you want to migrate the 2.0.1 configurations. Separate
each name with a space. Do not enter fully-qualified domain names or IP
addresses. For example, enter the following: sys1 sys2
3
Do one of the following:
If you are migrating the
configuration to more than
one system
If you are migrating the
configuration to a single
system
4
At the prompt for confirming that you want to migrate your configurations
to VCS One 5.0, enter y.
Completing the migration process
For the rest of the migration process, complete the same steps you would
complete during a regular Policy Master installation.
Upgrading from VCS One 2.0.1 to 5.0
Go to
step
4.
At the prompt asking you to confirm the migration to
a single system, enter the following: y.
Then, go to
step
4.
Upgrading the Policy Master
121
Advertisement
Table of Contents
Troubleshooting
