Configuring The Vcs One Policy Master Cluster - Symantec XGS-4728F Installation Manual

180 Sample installation output
Installing the VCS One Policy Master with NetApp

Configuring the VCS One Policy Master cluster

You can enter 'b' to go back to the first question.
You can enter '?' for additional information about the question.
Following each set of questions, you are asked to confirm the
information you have entered. To repeat the questions and correct
any previous errors, enter 'n' at the confirmation prompt.
No configuration changes are made to the systems until you answer
and confirm all configuration questions and VCS One PM is installed
successfully.
Press [Enter] to continue:
Veritas Cluster Server One 5.0.0 by Symantec
All nodes are configured to run the Policy Master from the Policy
Master cluster. The VCS One Policy Master cluster
availability to the Policy Master. To configure the Policy Master
cluster, the following information is required:
A cluster name
A unique cluster ID between 0-65535
Two or more NIC cards per system used for heartbeat links
One or more heartbeat links are configured as private links
One heartbeat link may be configured as a low priority link
Configuring all systems to create one cluster
Enter the unique cluster name: [?] my_cluster
Enter the unique Cluster ID between 0-65535: [b,q,?] 65530
Discovering NICs on thoropt158 ...................... Discovered
NIC : IP Address
------------------------
eth0 : none
eth1 : none
eth2 : 10.182.7.218
eth3 : none
Discovering NICs on thoropt159 ...................... Discovered
NIC : IP Address
------------------------
eth0 : none
eth1 : none
eth2 : 10.182.7.219
eth3 : none
Enter the NIC for the first private heartbeat link on thoropt158:
[b,q,?] eth0
provides high