Table of Contents
Advertisement
92
Upgrading and migrating to Symantec Endpoint Protection Small Business Edition
Disabling LiveUpdate in Symantec AntiVirus before migration
Disabling LiveUpdate in Symantec AntiVirus before
migration
4
Close the Services window.
Warning: Close the Services window or your upgrade can fail.
5
Repeat this procedure for all installations of Symantec Endpoint Protection
Manager.
To start the Symantec Endpoint Protection Manager service using the command
line
From a command prompt, type:
net start semsrv
To stop the Symantec Endpoint Protection Manager service using the command
line
From a command prompt, type:
net stop semsrv
If LiveUpdate runs on client computers during migration, conflicts may occur.
Therefore, you must turn off LiveUpdate on client computers during migration.
See
Migrating from Symantec Client Security or Symantec AntiVirus"
To disable LiveUpdate in Symantec AntiVirus
1
In the Symantec System Center, right-click a server group.
2
Click All Tasks > Symantec AntiVirus > Virus Definition Manager.
3
In the Virus Definition Manager dialog box, check Update only the primary
server of this server group, and then click Configure.
4
In the Configure Primary Server Updates dialog box, uncheck Schedule for
Automatic Updates, and then click OK.
5
In the Virus Definition Manager dialog box, uncheck the following selections:
Update virus definitions from parent server
Schedule client for automatic updates using LiveUpdate
Enable continuous LiveUpdate
on page 87.
Advertisement
Table of Contents
Troubleshooting
