Blue Tube Connection (From Faucet); Final Filter Installation - Watts Premier DELUXE PLUS Installation, Operation And Maintenance Manual

Blue Tube Connection (From Faucet)

Step 1 Locate the blue tube from the RO faucet. Measure the tube from the
faucet over to the storage tank and cut it to desired length. Remove
a brass nut, plastic sleeve and brass insert from the parts bag. To
assemble, place the brass nut on the tube first, then the sleeve (small
tapered end of sleeve must point to the end of tube) and then insert
the brass insert all the way into the end of the tube. (See Picture)
Step 2 Push the assembled blue tube into the open brass tank tee until it
stops. Slide brass nut and plastic sleeve down until you can thread
nut onto the tee. Use a wrench to securely tighten the brass nut
while continuing to push the tube into the tee.

Final Filter Installation

Step 1 Remove the seal caps from both ends of the final filter.
Step 2 Thread the two white plastic connectors into the final filter and tighten
with a wrench.
Note: Do not overtighten these connectors as it may damage them
or the final filter.
Cut the blue tubing between the RO faucet and the storage tank at
Step 3
a desired location to splice in the in-line final filter.
Step 4 With directional flow arrow on the filter pointing towards the faucet,
insert blue tubing from faucet into the fitting on the final filter (make
sure tube is pushed all the way into the fitting). Tighten with a 5/8"
wrench securely. Repeat this step to connect the blue tube from the
tank into inlet side of the final filter.
Note:
A connection to a refrigerator / ice maker may be tee'd into this blue tube and should
be spliced in between the final filter and the RO faucet.
Watts Premier offers an ice maker install kit part # 500010 (See Page 22).
Page 11