Operational Parameters; Contents Of Reverse Osmosis System; Tools Recommended For Installation - Watts Premier DELUXE PLUS Installation, Operation And Maintenance Manual

Operational Parameters

Do not use with water that is micro biologically unsafe or of unknown quality without adequate disinfection
before or after the system. System is intended to be installed on the cold water line only.
Operating Temperatures:
Operating Pressure:
pH Parameters:
Iron:
TDS (Total Dissolved Solids)
Turbidity
Hardness: Recommended hardness not to exceed 10 grains per gallon, or 170ppm. System will
operate with hardness over 10 grains but the membrane life may be shortened. Addition of a water
softener may lengthen the membrane life.
Water Pressure: The operating water pressure in your home should be tested over a 24 hour
period to attain the maximum pressure. If the incoming water pressure is above 85 psi a pressure
regulator is recommended and if over 100 psi then a pressure regulator is required. Should you
need a gauge to check your water pressure, see page 23 (item no. 261003).
Copper Tubing: Reverse Osmosis water should not be run through copper tubing as the purity of
the water will leach copper causing an objectional taste in water and pin holes may form in the tubing.
Watts Premier supplies speciality filters (part number 107008) that can be used if copper tubing
follows the Reverse Osmosis unit. Be sure to follow any state or local regulations during installation.
Contents of Reverse Osmosis (RO) System
5 Stage RO System has 3 vertical bowls. 4 Stage RO System has 2 bowls
1 Tank – Blue or White
1 Module – Blue or White (Filters Pre-Installed)
1 Parts Bag – With a 6" or 10" Final Filter
1 Faucet Bag
1 Manual
If any of the items are missing please contact Premier prior to installing.

Tools Recommended For Installation

√ 1 1/4" Hole Saw Bit for Faucet opening
√ Round Knock out Punch for Stainless Sinks 1/2" & 1¼"
√ Adjustable Wrench
√ Sharp Knife
√ 1 / 2" & 5/8" Open End Wrenches
√ Phillips Screw Driver and bit
√ Needle Nose Pliers – Adjustable Pliers
√ Electric Drill
√ 1/8", 1/4" & 3/8" Drill Bits
Maximum 100°F (37.8°C)
Maximum 85 psi (6.0 kg/cm
Maximum 11
Maximum 0.2 ppm
< 1800 ppm
< 5 NTU
Page 5
Minimum 40°F (4.4°C)
2
) Minimum 40 psi (2.80 kg/cm
Minimum 2
.
2
)