Red 1/4" Tube Connection (From Faucet); Tank Tee Installation; Blue Tube Connection (From System) - Watts Premier DELUXE PLUS Installation, Operation And Maintenance Manual

Red 1/4" Tube Connection (from faucet)

Step 1 Using the white plastic union found in the parts bag, determine where
the 1/4" red tubing from the faucet and the 1/4" black tubing from
the RO membrane housing would join together comfortably. Cut
to length leaving a straight cut edge on both tubes. Insert the red
tube in one end of the white plastic union and the black tube in the
other end. Use a 5/8" wrench to tighten both of the white plastic
nuts securely.
Tank Tee Installation - Part# 131023
Step 1 Teflon tape must be applied in a clockwise direction. Wrap 7 to 12
turns around the male pipe threads (MPT) on the Stainless Steel
fitting on top of the tank.
Step 2
Thread the brass tee (supplied in the parts bag) onto the brass
connection on the top of the tank and tighten using an adjustable
wrench.
Caution: Do not apply Teflon tape to the tee's compression fitting
threads. If taped, it will leak.

Blue Tube Connection (From System)

Step 1 Position the RO storage tank in a desired location. You may stand it
upright or lay it on its side (using the black plastic stand included).
Locate the blue tube from the RO module. Measure the tube from
Step 2
the unit over to the storage tank and cut it to desired length. Remove
a brass nut, plastic sleeve and brass insert from the parts bag. To
assemble, place the brass nut on the tube first, then the sleeve (small
tapered end of sleeve must point to the end of tube) and then insert
the brass insert all the way into the end of the tube. (See Picture)
Step 3 Push the assembled blue tube into the brass tank tee until it stops.
Slide brass nut and plastic sleeve down until you can thread nut
onto the tee. Use a wrench to securely tighten the brass nut while
continuing to push the tube into the tee.
Page 10