Table of Contents
Advertisement
Blue Tube Connection
Locate blue tube in the Filter-Pure Box. To assemble, place the brass
Step 14
nut on the tube first, then the sleeve (small tapered end of sleeve must
point to the end of tube) and then insert the plastic insert all the way
into the end of the tube. (See Picture)
Insert the assembled blue tube into the end of the faucet shank until
Step 15
it stops.
Slide brass nut and plastic sleeve down until you can thread
nut onto the faucet shank. Use a wrench to securely tighten the brass
nut.
Attach the open end of the blue tube into the right side of the system
Step 16
by pushing it into the quick connect elbow fitting (above Purple UF
Membrane filter).
Mounting System Under Sink
Locate an area best fitted for mounting the system. Allow approximately 2" (5cm) clearance
Step 17
between the bottom of the filter housing and the floor of the sink cabinet.
Using the mounting holes on the bracket, mark the location for the mounting screws on
Step 18
the cabinet wall under the sink.
Screw the (2) self tapping screws into the wall at the marked location.
Step 19
Hang the module on the screws using the mounting holes in the bracket.
You have completed the installation of new your Filter-Pure system.
System Start Up
Step 20
Turn on water supply at angle stop and open the Adapt-a-Valve. Turn faucet handle to the
open position to start the flow of water through the unit. Run 3 gallons of water through
the unit in order to flush out the normal black carbon fines (it will "sputter" until the air is
purged out) from the unit. Initially, the water may appear cloudy which is due to tiny air
bubbles and it will clear up shortly. Close the faucet when finished.
Step 21
Check for leaks. If you have any leaks, shut off the water supply to your system, tighten
any fittings / housings and restart unit.
(Check frequently over the next 24 hours to ensure no leaks are present)
Congratulations!
Please Follow the Startup Instructions.
8
Hide quick links:
Advertisement
Table of Contents
