Code 39 Check Character; Code 39 Message Length - Datalogic PowerScan 7000 2D Product Reference Manual

Symbologies

Code 39 Check Character

indicates that the imager reads and transmits bar code
No Check Character
data with or without a check character.
When Check Character is set to , the unit only
Validate, but Don't Transmit
reads Code 39 bar codes printed with a check character, but will not
transmit the check character with the scanned data.
When Check Character is set to , the imager only
Validate and Transmit
reads Code 39 bar codes printed with a check character, and will trans-
mit this character at the end of the scanned data. Default = No Check
Character.
* No Check Character
Validate, but Don't Transmit
Validate and Transmit

Code 39 Message Length

Scan the bar codes below to change the message length. Refer to
Mes-
for additional information. Mini-
sage Length Description on page 6-2
mum and Maximum lengths = 0-48. Minimum Default = 0, Maximum
Default = 48.
Minimum Message Length
Maximum Message Length
®
6-6 PowerScan 7000 2D