Manual Disarming - Vision 1480 Series Owner's Manual

ARMING & DISARMING

MANUAL DISARMING

You can manually Disarm using a secure code in the event your
factory remote's battery dies (see Note 2 below). The factory set
code is "6", but you can change this code to another number of
your choosing for greater security (see the bottom of this page).
1) Enter the car. (The siren will go off. You can leave the door open or closed.)
2) Turn ON the Ignition.
3) Within 30s, press the Program Switch the same number of times as
your Disarm Code. (Factory Default Code = 6)
4) Turn OFF the Ignition. (The 1480 will now Disarm and the siren will
stop. NOTE
NOTES
1) If the 1480 won't Disarm, you entered the code incorrectly. Close the
door, wait for the siren to stop, then start over from Step-1.
2) Many Push Start cars don't allow the Ignition to be turned on with-
out the presence of the Factory Remote. So if you lose or destroy your
car's remote, you may not be able to Manually Disarm the 1480. But if
your remote's battery merely dies, you will be able to switch on the Igni-
tion and Manually Disarm using the 4 steps above.
DISARM CODE CUSTOMIZATION
The factory code is "6" but you should change it to another number between 1 & 30:
1) With the 1480 Disarmed, turn ON the Ignition.
2) Press the Program Switch for 6s, after which the siren will chirp 3 times.
3) Release the Program Switch and turn OFF the Ignition. The Status LED
will light for 5s.
4) Turn ON the Ignition again (while the LED remains lit for 5s).
5) When the LED turns off, wait about 4s and you will see the LED start to
If you have the optional paging system, you must now relearn your pagers.
5
Turn OFF the Ignition to program your code.
PROGRAMMABLE
© 2 0 1 1 - 2 0 1 4 K I R A M E K , I N C .
-