Programmable Features - Vision 1480 Series Owner's Manual

PROGRAMMABL E FEATURES
You can change some features of the 1480 by using the Program
Switch. Perform the following 4-step procedure to change the fea-
tures shown in Table-2:
1. Start the engine and then Stop the engine.
2. With the Ignition OFF, Arm the 1480 and then immediately Disarm.
3. Within 20s, turn ON the Ignition.
4. Press the Program Switch the same number of times as the feature you
want to program — refer to the "No." column in Table-2 below. (For
5. Turn OFF the Ignition.
NOTES
1)
programmed settings. To program another setting, repeat the 4 steps.
2)
TABLE-2
No. Feature Description
3 Ignition Trigger
4 Hazard Flash During Remote Start
7 Door Ajar Hazard Flash
8 Auto Arm
9 Siren Output
10 Auto Rearm
15 Speed Controlled Door Locking
17 Exterior Illumination
11 11
FACTORY DEFAULT SETTINGS SHOWN IN BOLD TEXT ABOVE
h the Program Switch 8 times.)
Feature Selection Menu
Toggle Settings
IG Protect
OFF
OFF
OFF
Continuous
OFF
OFF
OFF
© 2 0 1 1 - 2 0 1 4 K I R A M E K , I N C .
)
-
RSCM
ON
ON
ON
Pulsed
ON
ON
ON