Vision 1480 Series Owner's Manual page 42

TROUBL ESHOOTING
CAN LEARNING SUCCESSFUL, BUT ALARM OPERATION IS ERRATIC.
•
mon reason for unexplained alarm behavior. This should not be a prob-
and Ground wiring if you manually connected them.
If your power source is truly stable, then the best alternate explana-
•
for, the alarm may function correctly sometimes but not at other times.
Tool required, or visit your VISION dealer.)
SHOCK SENSOR ONLY "FULL TRIGGERS." THERE'S NO WARNING TRIGGER.
View the sensor's LEDs when you hit the car's body. If the Green LED
•
doesn't light, slightly increase the sensitivity of the shock sensor.
If the Green LED lights, perhaps you're testing too quickly. After Lock-
•
ing/Arming, you must wait 10s before you can test the shock sensor.
SHOCK SENSOR GIVES REPEATED WARNING TRIGGERS.
If the sensitivity of the sensor is too high and/or if the mounting location
•
is incorrect, the sensor may be triggering on the otherwise undetectable
sounds of the hazard light relay switching, or even the siren vibration.
Reduce sensitivity and/or change the mounting location of the sensor.
19
© 2 0 1 1 - 2 0 1 4 K I R A M E K , I N C .
-