Troubleshooting - Vision 1480 Series Owner's Manual

CAN LEARNING NOT SUCCESSFUL.
If you manually connected Power and CAN (pages 9-10) instead of us-
•
CAN-L are reversed, you of course will not be able to learn the vehicle's
CAN signals. Also note that the vehicle's CAN wires are normally a
"twisted" pair. So if you connected CAN-H and CAN-L to wires that are
not twisted, you probably chose incorrect wires.
•
year is very important.
•
is installed in the 1480.
Are you using the OBD connector on a car other than Toyota, Nissan or
•
Lexus? If so, it will not work. At this time, we do not support OBD con-
nections on cars other than Toyota, Nissan and Lexus.
If all else fails, try the following CAN LEARNING STEPS instead of those
•
given on page 14:
1) Disconnect the white 6-cavity connector of the Main Harness OR re-
power to the 1480 control module.) Wait about 10 seconds.
2) Press-and-hold the Program Switch, and at the same time reconnect
the Main Harness or reinsert the Fuse. You should now hear the siren
blast, and you will notice the LED is lit. (The 1480 has now been reset
to its factory state.)
3) Release the Program Switch. The siren will shut off but the LED will
remain lit.
4) Switch ON the Ignition. The LED will turn OFF. (And the siren may
or may not chirp 3 times.)
5) Switch OFF the Ignition. The LED will light for 5 seconds, turn off
CAN signals are now learned. Wait 10 seconds before you begin testing.
© 2 0 1 1 - 2 0 1 4 K I R A M E K , I N C .
TROUBL ESHOOTING
18