Read This First - Vision 1480 Series Owner's Manual

READ THIS FIRST

ALARM FIRMWARE & ONE-TIME LEARNING
FIRMWARE
This product only works on select cars that have a compatible digital CAN-
BUS communication system. If your car is not on our compatibility list, this
1480 product will not function at all! We do not accept product returns due
to CAN-BUS data mismatching, so make absolutely sure prior to purchase
CAN has been programmed into the 1480 product (by your authorized VI-
SION dealer or by our company, KIRAMEK, Inc.) Visit our website for the
latest Compatibility List:
http://visionsecurity.jp/en/systems/
ONE-TIME LEARNING
After you have connected the four CAN & Power wires and the Siren wire
(pages 6-12), you will need to perform the CAN Signal Learning steps on
page 14. You must do the CAN Learning steps even though the 1480 has
ELECTRICAL CONNECTIONS
The two Power wires and two CAN wires are the most critical connections
of the 1480. Always use the included PosiTap connectors to make these four
connections. If you lose any connectors, purchase replacements. If you can-
not do that, use solder instead. But NEVER use electrotaps or T-taps which
can loosen over time and result in system malfunction. And if you use solder,
always tape your connection so it doesn't short on any metal or other wires.