Can Signal Learning - Vision 1480 Series Owner's Manual

matched to your car. The 1480 will be completely disabled until you com-
plete the steps below. You only need to do it once.
NOTE
Performing this initial setup procedure automatically resets all func-
tions to their factory defaults. This includes a reset of the Program-
mable Features (Owner's Guide page 11), and resets any custom Manual
Disarm Code you may have programmed (Owner's Guide page 5). If you
have the optional Paging System installed (p/n TR537S or TR835S), all
pagers will be erased from memory and you will have to relearn them.
And if you have performed this CAN Learning procedure before, any
previously learned CAN signals will be overwritten.
1) Disconnect the white 6-cavity connector of the Main Harness OR remove
1480 control module.) Wait about 10 seconds.
2) Switch ON the Ignition*.
3) Press-and-hold the Program Switch, and at the same time reconnect the
Main Harness or reinsert the Fuse. You should now hear the siren blast,
and you will notice the LED is lit. (The 1480 has now been reset to its fac-
tory state.)
4) Release the Program Switch. The siren will shut off and the LED will
turn off. (And the siren may or may not chirp 3 times.)
5) Switch OFF the Ignition.
a few seconds.)
6) Lock and Unlock. Vehicle CAN signals are now learned. Wait 20 seconds
before you Lock again, otherwise you may enter Sensor Bypass Mode (see pg.
3 in the Owner's Guide for details of that mode).
*NOTE: If the above steps do not work (i.e., the 1480 won't function), you may
need to start the engine in Step (2) above rather than just switch the Ignition ON.
(This issue occurs only on some Hybrid cars.)
© 2 0 1 1 - 2 0 1 4 K I R A M E K , I N C .
C AN SIGNAL L EARNING
14