Arming & Disarming; Arming; Confirmation Chirps - Vision 1480 Series Owner's Manual

Arming & disarming

ARMING

NORMAL ARMING
Close all doors and then LOCK by your factory
keyless remote or by SmartKey door handle
touch.
ON). The Status LED will light for 5s, during which
time all triggers are disabled. Then the Status LED
triggers become enabled. The Shock Sensor (and any other external sen-
SENSOR BYPASS ARMING
OFF
This procedure lets you temporarily disable
the Shock Sensor for a single Arming session:
1) With Ignition OFF, press the Program Switch twice.
2) Within 20s, press LOCK on the factory remote to Arm.
The system is now Armed in Sensor Bypass Mode, and all triggers are active
except the shock sensor and any other external sensors. Note that when you
Disarm and then Arm again normally, the shock sensor will be enabled.

CONFIRMATION CHIRPS

OFF
This procedure lets you enable or disable the
Arm/Disarm chirps. (Note that the siren will
still go off when the 1480 is triggered.)
1) With Ignition OFF, press the Program Switch once.
2) Within 20s, press LOCK on the factory remote to Arm.
3
(ON by default)
PROGRAMMABLE
V I S I O N 1 4 8 0 O W N E R ' S G U I D E
LOCK
2 Pushes
1 Push
-