Power Supply - Pepperl+Fuchs FUQ-B8 Manual

VB24
ID- ID-NET™ network -
Shield Network Cable Shield
* Do not leave floating, see par. 4.2.2 for connection details.
To avoid electromagnetic interference when the scanner is connected to a
CBX connection box, verify the jumper positions in the CBX as indicated in
its Installation Manual.
NOTE

4.1 POWER SUPPLY

Power can be supplied to the scanner through the CBX100/500 spring clamp terminal pins as
shown in Figure 20:
The power must be between 10 and 30 Vdc only.
It is recommended to connect the device CHASSIS to earth ground (Earth) by setting the
appropriate jumper in the CBX connection box. See the CBX Installation Manual for details.
36
Main Interface
RS232
TX
RX
RTS
CTS
SGND
Power Supply
VGND
V+ Earth
in Ground
Figure 20 - Power Supply Connections
RS485
Full-Duplex
TX+
*RX+
TX-
*RX-
SGND
RS485
Half-Duplex
RTX+
RTX-
SGND