Step 6 - Test Mode - Pepperl+Fuchs FUQ-B8 Manual

VB24
STEP 6 – TEST MODE
Use a code suitable to your application to test the system.
1. Enter the Test mode function by holding the Mode push button pressed until the TEST
LED is on.
2. Release the button to enter the Test mode function.
Once entered, the Bar-Graph on the five LEDs is activated and if the scanner starts
reading barcodes the Bar-Graph shows the Good Read Rate. In case of no read condition,
only the STATUS LED is on and blinks.
READY
GOOD
TRIGGER
COM
STATUS
3. To exit the Test Mode, press the Mode push button once.
By default, the Test Mode exits automatically after two minutes.
NOTE
FOCUS
SETUP
LEARN
TEST
Figure 9 – Mode Interface: Test Mode Function
green
green
yellow
yellow
red
15