Auto Learn - Pepperl+Fuchs FUQ-B8 Manual

VB24

Auto Learn

If you are configuring your scanner using Mode push button, you must start with the Auto
Learn procedure.
1. Enter the Auto Learn function by holding the Mode push button pressed until the LEARN
LED is on.
2. Release the button to enter the Auto Learn function.
Once entered, the reader starts a procedure to automatically detect and recognize
barcodes (by type and length), which are presented to it (*). The laser turns on and the
LEARN LED blinks to indicate the ongoing process.
READY
GOOD
SETUP
TRIGGER
LEARN
COM
TEST
STATUS
Figure 5 – Mode Interface: Auto Learn Function
3. Exit the process by pressing the Mode push button once. The scanner will restart at the
end of the process, and then the detected barcodes are automatically configured in
scanner memory.
If the barcode cannot be read because of low contrast or excessive ambient
light, you can perform the AutoSetup function to optimize the optical
parameters. Then you can perform AutoLearn to recognize the barcode
NOTE
symbology.
On exit from Autolearn, the following parameters are forced: Code
Combination = Single Label, Reading Mode = Linear. If necessary, these
parameters can be changed through Genius™.
NOTE
FOCUS
green
green
yellow
yellow
red
The procedure is as follows:
A) place the desired barcode on
the scanline.
B) wait until the LEARN LED
stays steady on (indicating the
reader has
barcode).
C) repeat, if needed, the above
two steps to program up to 10
different barcodes (the LEARN
LED returns to the blinking
state for the next code). If more
than one barcode is detected
in the scan line, the Multi Label
mode is enabled.
detected the
7